Privacy statement: Your privacy is very important to Us. Our company promises not to disclose your personal information to any external company with out your explicit permission.
News
Industry trend: membrane nitrogen generator switch to PSA nitrogen generator 2018-01-09
For oil field, maximizing the oil exploitation efficiency is very important, good oil exploitation ratio increases the production and increase the return of investment. In the past, some oil wells are only exploited once, with the technology development, more and more oil companies use nitrogen to collect more oil. For the supplying of nitrogen, in the past, most oil companies are using membrane type nitrogen generator, because membrane nitrogen generator has advantage of smaller size, easy operation,etc. 600 Nm3/hr, 900 Nm3/hr and 1200 Nm3/hr membrane nitrogen generators are widely used in field. After years development, nowadays more and more companies are using PSA nitrogen generator to replace the membrane type. Main reasons are the PSA type machine investment is much lower than the membrane type. Also the maintenance cost is much lower. For same specification, PSA nitrogen generator only cost half of the membrane type. Details welcome to contact us.
How does PSA oxygen generator work? 2017-12-22
PSA oxygen generator is a machine producing oxygen by separating oxygen from air. It adopts the principle of PSA(pressure swing adsorption). Pressure swing adsorption processes rely on the fact that under pressure, gases tend to be attracted to solid surfaces, or "adsorbed". The higher the pressure, the more gas is adsorbed; when the pressure is reduced, the gas is released, or desorbed. Oxygen generator process flow The main process flow of PSA oxygen generator is as following: Air compressor suction air from atmosphere,then the compressed air enters one air treatment part to get rid of dust,water, dust,etc, achieving clean and dry compressed air. This air treatment part mainly consists of three filters, one refrigerant dryer and one activated carbon oil remover. After treatment, the compressed air enters one air tank to make air stable. Then the compressed air enters PSA nitrogen/oxygen separator. After passing through this nitrogen/oxygen separator part, oxygen is collected. The produced oxygen enters one oxy
How does PSA nitrogen generator work? 2017-12-22
PSA nitrogen generator is a machine producing nitrogen by separating nitrogen from air. It adopts the principle of PSA(pressure swing adsorption). Pressure swing adsorption processes rely on the fact that under pressure, gases tend to be attracted to solid surfaces, or "adsorbed". The higher the pressure, the more gas is adsorbed; when the pressure is reduced, the gas is released, or desorbed. Nitrogen generator process flow The main process flow of PSA nitrogen generator is as following: Air compressor suction air from atmosphere,then the compressed air enters one air treatment part to get rid of dust,water, dust,etc, achieving clean and dry compressed air. This air treatment part mainly consists of three filters, one refrigerant dryer and one activated carbon oil remover. After treatment, the compressed air enters one air tank to make air stable. Then the compressed air enters PSA nitrogen/oxygen separator. After passing through this nitrogen/oxygen separator part, nitrogen is collected. The produced nitrogen enters one nitrogen buffer tank. At the outlet of nitrogen buffer tank, stable and qualified nitrogen is sent to using point.
Gamma 99.99%, 128 Nm3/hr nitrogen generator to Chile 2017-12-22
Three months after delivery of 295-110 nitrogen generator, this 49-128 nitrogen generator has been finished test and heading for Chile
Chile nitrogen generator under test 2017-12-22
This nitrogen generator under test has purity of 99.5%, 110 Nm3/hr flow rate. It is for a customer in Chile.
Gamma nitrogen generator, oxygen generator delivered to Malaysia 2017-12-22
After purchased one 99.9% purity, 90 Nm3/hr flow rate nitrogen generator in early this year, now our Malaysia customer purchased three sets machine at one time: one 95% purity, 200 Nm3/hr, one 99% purity, 300 Nm3/hr nitrogen generator and one 93% purity, 100 Nm3/hr oxygen generator. Below are two photos
Gamma 99.9% purity, 90 Nm3/hr nitroge generator delivered to Malaysia 2017-12-22
One of our Malaysian customers need one PNM39-90 nitrogen generator urgently, therefore Gamma delivered this nitrogen generator to them only 15 days after arrival of advance payment. Normally the lead time is 50-60 days.
Gamma nitrogen generator delivered to Europe 2017-12-22
In March, 2016, Gamma delivered another nitrogen generator to our distributor in the Netherlands, HYGEAR company. HYGEAR company not only distributes our nitrogen/oxygen generator in the Netherlands, it is also Gamma after-sales service provider for all Gamma nitrogen/oxygen generators in Europe.
Gamma 99.95% purity, 1000 Nm3/hr flow rate nitrogen generator installed 2017-12-22
For big flow rate nitrogen generator, the adsorption material-carbon molecular sieve(CMS) is of critical importance. Because Gamma is one of the three manufactures in China can use world best CMS, GN-UC-H from Iwatani/Kuraray, Japan, this customer finanly chose Gamma to supply their 99.95% purity, 1000 Nm3/hr nitrogen generator. Now this machine is working very well at customer site.
Gamma 99.995% purity nitrogen generator for laser cutting machine 2017-12-22
Nitrogen generator for laser cutting need high purity, compact structure. Gamma is currently the only Chinese company manufactures this nitrogen generator. Gamma nitrogen generator for laser cutting has four purity range:99.99%, 99.995%, 99.999% and 99.9995% and two flow rate range: 25 Nm3/hr and 45 Nm3/hr. For each machine, the purity and flow rate can change according to site need.
Gamma 99% purity, 40 Nm3/hr nitrogen generator installed at site 2017-12-22
After visiting several Chinese manufacturers, our Pakistan customer finally selected Gamma to manufacture his small nitrogen generator 99% purity, 40 Nm3/hr. To faciliate export installation, the whole system is installed on one skid, equipped with SIEMENS SMART 700 touch screen. After connecting air compressor and power supply, with a simple touch on the screen, the nitrogen generator starts to run. No need for site installation, complicated operation procedure,etc.
Gamma nitrogen generator for Pakistan customer delivered 2017-12-22
After comparison among Chinese suppliers, this Pakistan customer finally choose Gamma nitrogen generator. It is a 300 L/min flow rate, 99.5% purity nitrogen generator use for his plastic injection machine. To facilitate site installation, this nitrogen generator is mounted in one skid. With SIEMENS touch screen. With one touch, the nitrogen generator stars to run.
Gamma Gas ERP system launched 2017-12-22
In Sept 2014, the ERP system of Jinan Gamma Industry Co.Ltd launched successfully, which marks the completion of ERP first stage construction. Gamma ERP laid a foundation for the integration of Gamma financial and business management. At present, most Chinese PSA oxygen/nitrogen geneator manufacturers don't have good management, also because of the gas natures of oxygen/nitrogen generators, most companies could not provide satisfactory products and service to customer. To further improve Gamma management, Gamma deeply cooperates with top manufacturing field ERP service provider, DigiwinSoft, re-constructed management process, regulated methods, renewed concepts, finished activies such as business management manual, system function development, basic data collection, system integration test, operation training,etc in a quite short time, realized the optimal allocation of human resources, financial resources and material, providing further driving force for enterprise development.
Gamma Gas 99.99%, 80 Nm3/hr nitrogen generators for Iwatani/kuraray 2017-12-22
Gamma is the key cooperator of Iwatani/Kuraray, Japan, which is the best CMS manufacturer. Gamma is one of the only three China manufacturers having the right to use their best CMS GN-UC, its performance is much better than most Chinese manufacturers GN-1.5H. More over, for many Iwatani's own customers, it cooperate with Gamma to supply nitrogen generators, of course using their best CMS. Here are two machines for Iwatani/Kuraray customer, it is 99.99% purity with 80Nm3/hr flow rate:
Gamma nitrogen generator export to Myanmar 2017-12-22
After thorough comparison among Chinese manufacturers, this Myanmar customer decided to purchase their 99.9% purity, 40 Nm3/hr nitrogen generator from Gamma. For overseas customers, now Gamma is supplying machine with skid mounted, one touch to operate, no need for Gamma engineer to go to site, saving customer's cost and waiting time. It also shows the simplicity of Gamma nitrogen generator operation. Here are some photos of their machine.
Two sets 99.9%, 1200 Nm3/hr nitrogen generator delivery 2017-12-22
After 1 year comparison among Chinese manufacturers, this customer decided to choose Gamma to supply their 2 pcs nitrogen generators with 99.9% purity, 1200 Nm3/hr flow rate.Here are some photos when machines leave Gamma factory.
Sri Lanka customer 99.99%, 100 Nm3/hr N2 generator 2017-12-22
After one nitrogen generator working soundly for more than 6 years, one customer in Sri Lanka expands their production line, which need another 99.99% purity, 100 Nm3/hr flow rate nitrogen generator. This machine has been delivered to Sri Lanka in 2013, here are some photos before delivery.
Gamma 98% purity oxygen generator in Fiji 2017-12-22
To meet with customer's metal cutting application, Gamma developed the 98% purity oxygen generator. Gamma is the first and only Chinese company manufacturing real 98% purity oxygen generator. This plant now is working in Fiji.
Gamma Gas 14 sets 99.99% purity, 100 Nm3/hr nitrogen generators for Foxconn 2017-12-22
As a major player in PSA high purity nitrogen generators in China, Gamma Gas wins customer with our quality product and service. Gamma Gas is long time supplier for World Top 500 company Foxconn, providing high purity nitrogen for their electronics application. Here are some Gamma nitrogen generators installed in Foxconn site.
150 Nm3/hr oxygen generator for Vietnam customer 2017-12-22
With the sound operation of 100 Nm3/hr oxygen generator in Vietnam, another Vietnam customer ordered two oxygen generators, one with 100 Nm3/hr, the other with 150 Nm3/hr flow rate. Now these two machines are combined in their workshop, providing constant gas for end application.
Privacy statement: Your privacy is very important to Us. Our company promises not to disclose your personal information to any external company with out your explicit permission.
Fill in more information so that we can get in touch with you faster
Privacy statement: Your privacy is very important to Us. Our company promises not to disclose your personal information to any external company with out your explicit permission.